Plumbers in Ballarat provide plumbing services for the Ballarat and Geelong areas. The plumbers provide general or specialized service to all your plumbing problems.
Clogged drains are the number one plumbing problem in Australia. At first it may seem impossible to do anything about it, but if you know what you’re doing, it’s really not that hard. Here’s how to clear your clogged drain.
Blocked drains are usually caused by a sewer line backed up into a holding tank, or if there is too much sediment on the bottom of the drain, or if the container has been sitting in water for a long time. If your drain is clogged, there will be a large amount of sediment at the bottom of the drain, making it difficult to remove and have a full flow of water. If your plumber can remove the sediment and clean your drain, they will tell you.
Clogged drains are almost always caused by an obstruction in the pipe, so any appliance, fixture or other item that sits in the area will be the culprit. Plumbers in Ballarat specializes in plumbing problems in the Ballarat and Geelong areas.
You must have a gas fitter for this process. The gas fitter has the proper equipment and is able to safely and efficiently remove the blockage from your sink. A plumber can also do this as part of his routine plumbing inspection. However, if you have a clogged sink with a lot of sediment, it’s best to call a gas fitter to do the job right.
If you have gas in your home or a gas fitter, and the water pressure is too low, your plumber will likely come out to your home. Water may be low, and the sink drain is backed up and full of sediment. He will then do a check to see how much sediment is in the drain.
Once the plumbers in Ballarat sees how much sediment is in the drain, it’s time to replace the liner. When the clog is complete, it will probably be difficult to pass water through the drain. The current gas line or heater may be frozen. The use of a tool called a Gas Cut Off Valve will solve this problem. This is also an effective way to reduce pressure in the gas line, which will prevent a blockage from happening again.
The blockage is removed and the drain is filled with enough water to clear the blockage. The clog should be completely removed by the plumber before he starts to clean the drain. It’s better to have the blockage removed before it becomes more problematic.
If the clogged drains are too big, it is recommended that the plumber uses the method of ‘kicking’ to remove the blockage. This method involves using a heavy duty trash bag to knock the blockage from the pipe. The handle of the trash bag is used to hit the wall of the pipe, where the clog is lodged, and then a backhoe will be used to remove the blockage.
Sometimes, toilets will clog up and need to be cleaned out. In these cases, the sink drains should be cleaned out also, and gas fitter will take over. They will be able to empty the pipes of all the debris, and clean out the clogs and any backed up drains.
The drain line will usually be covered with a rubber boot and will not be visible to the homeowner. The pipes will then be flushed out. This will help prevent a pipe from backing up, which could lead to a pipe burst.
If you have an issue with a clogged sink or are unsure of how to remove the blockage, or clog in the first place, it is best to consult plumbers in Ballarat. They will be able to provide accurate, professional plumbing solutions that will ensure your drains are cleaned out and ready to go once again.